im trying to get my 6 foot fiberglass dish to use two motors
im not so good with one motor because its just plain difficult for
i've gone as far as getting myself with all this equipment.
and am planning on getting a new tbs card
will get a 6 inch elevation actuator i seen in this pic have had time to look it up
and could not find a better solution than mine with the receiver put to use
so here is my picture
and the picture of where i saw this i will post it up too
read info in picture to see if it will work at all
other than that i will need some lnbs
the cone actuator 6"
another v box
and a dual tuner pci-e card and blindscan software
each must be scan twice a sum of 4memories for one sat
for all four polarization
two memories only for dual polarization lnbs
just setup the receiver!!!!dammit
im not so good with one motor because its just plain difficult for
i've gone as far as getting myself with all this equipment.
and am planning on getting a new tbs card
will get a 6 inch elevation actuator i seen in this pic have had time to look it up
and could not find a better solution than mine with the receiver put to use
so here is my picture
and the picture of where i saw this i will post it up too
read info in picture to see if it will work at all
other than that i will need some lnbs
the cone actuator 6"
another v box
and a dual tuner pci-e card and blindscan software
each must be scan twice a sum of 4memories for one sat
for all four polarization
two memories only for dual polarization lnbs
just setup the receiver!!!!dammit